[نواف]

This page will take a long time to load so hang tight!

I wanted to prove that I actually do some work around here!


Here you can see Ron drawing in the window outlines.





Steve gets in on the act and does some "eyeballing"


Steve applies tape to the line strokes that will enable him and Ron to make tem,plates for the other side. Pretty smart!.



Taped outlines are in place and almost ready for the templates. We adjusted the rear window somewhat after this shot. It appeared to be too long.



Close up on the front window.

Ron and Steve doing up the templates and rechecking them.


Me hard at work again!


I was cringing at this point as Ron walked up and started cutting the shell. Getting this thing in my basement is going to be a tricky one.




Cut in two sections.



Cut in three sections.



Removable Hardtop? Hmmm.. Breezy flying conditions I would think!

(Ron left the windows in place to maintain structural integrity)



Sectioned and ready for transport to see if they will fit down the stairs. Hopefully next week we take a run at this.

يتبع..............